If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Compile: File Not Found
HELP! I don't know what happened. I was just doing basic cleanup of forms and
reports. Now any event that fires gives me an error - all based on "File Not Found". (ex On Load you entered as the event property setting produced the following error: File Not Found"). I have done Compact/Repair. Also when I compiled the code I get a "File Not Found" error. Does anybody have any ideas? I dont know what I did - things were working just fine then all of a sudden this issue - I was not modifying/adding any code. -- Message posted via http://www.accessmonster.com |
#2
|
|||
|
|||
Compile: File Not Found
szag,
Do you have a back-up? You don't have to modify code to *clean-up* something that is being used by your code. You could hold down the Shift Key open your database and go to the VBA Editor and start reading to see what you *cleaned up* that your code was using or go to a back-up copy and start again confirming that nothing you cleaned was/is being used by your code. -- Gina Whipp 2010 Microsoft MVP (Access) "I feel I have been denied critical, need to know, information!" - Tremors II http://www.regina-whipp.com/index_files/TipList.htm "szag via AccessMonster.com" u2885@uwe wrote in message news:a6616db7e7f63@uwe... HELP! I don't know what happened. I was just doing basic cleanup of forms and reports. Now any event that fires gives me an error - all based on "File Not Found". (ex On Load you entered as the event property setting produced the following error: File Not Found"). I have done Compact/Repair. Also when I compiled the code I get a "File Not Found" error. Does anybody have any ideas? I dont know what I did - things were working just fine then all of a sudden this issue - I was not modifying/adding any code. -- Message posted via http://www.accessmonster.com |
Thread Tools | |
Display Modes | |
|
|