If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Warnings keep on Appearing
I have a video clip on a slide. Every time I run it I get
a Security Warning - even though my Macro Security Level is 'Low'. How do I get rid of the warnings. |
#2
|
|||
|
|||
Is this in PowerPoint 2003? How did you insert the video? If you use Insert
Movies and Sounds Movie from File you shouldn't get the message you mention. "Brian McGuigan" wrote in message ... I have a video clip on a slide. Every time I run it I get a Security Warning - even though my Macro Security Level is 'Low'. How do I get rid of the warnings. |
#3
|
|||
|
|||
I created a Video Clip .exe file using Camtasia Studio 2.
pasted a screen-shot into Powerpoint and created a hyperlink from it to the .Exe file. -----Original Message----- Is this in PowerPoint 2003? How did you insert the video? If you use Insert Movies and Sounds Movie from File you shouldn't get the message you mention. "Brian McGuigan" wrote in message ... I have a video clip on a slide. Every time I run it I get a Security Warning - even though my Macro Security Level is 'Low'. How do I get rid of the warnings. . |
#4
|
|||
|
|||
Try using Action Settings Run and point to your EXE file.
"Brian McGuigan" wrote in message ... I created a Video Clip .exe file using Camtasia Studio 2. pasted a screen-shot into Powerpoint and created a hyperlink from it to the .Exe file. -----Original Message----- Is this in PowerPoint 2003? How did you insert the video? If you use Insert Movies and Sounds Movie from File you shouldn't get the message you mention. "Brian McGuigan" wrote in message ... I have a video clip on a slide. Every time I run it I get a Security Warning - even though my Macro Security Level is 'Low'. How do I get rid of the warnings. . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Getting rid of Security Warnings in Access 2003 | ChuckW | Running & Setting Up Queries | 1 | September 15th, 2004 03:12 PM |
How to set warnings before making any changes with Contacts,... | jbw423 | General Discussions | 1 | August 29th, 2004 12:41 AM |