If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Custom size drawing reduce size to fit pasted object - don't want
I am using Visio 2003 standard.
I created a custom page which is 4.2135 x 3.3117 inches. When I paste a Visio object into my page and save it, the custom page resize itself to the size of the pasted object (which in my case smaller then my original page size I created). I would like the size of my custom page fix in size and don't change. How do do this ??? I did this: 1) Print setup, I just used letter size Page size) I used custom size and set it to 4.2135 x 3.3117 landscape. The print zoom shows fix exactly 1 sheet. I would appreciate any help !!! If I put a border around the original custom size, the the will not change. Thank You, G |
#2
|
|||
|
|||
Custom size drawing reduce size to fit pasted object - don't want
When you set a custom page size it should remain the same. What is the object
that is being pasted into Visio? At which point do you lose your page settings when you drop the object on the page or when the drawing is reopened? If the radio button for size to fit drawing contents is not checked it should not change the paper size. Do you have the latest drivers for your printer and operating system? -- James W. "Gary" wrote: I am using Visio 2003 standard. I created a custom page which is 4.2135 x 3.3117 inches. When I paste a Visio object into my page and save it, the custom page resize itself to the size of the pasted object (which in my case smaller then my original page size I created). I would like the size of my custom page fix in size and don't change. How do do this ??? I did this: 1) Print setup, I just used letter size Page size) I used custom size and set it to 4.2135 x 3.3117 landscape. The print zoom shows fix exactly 1 sheet. I would appreciate any help !!! If I put a border around the original custom size, the the will not change. Thank You, G |
Thread Tools | |
Display Modes | |
|
|