If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Autofit text in table cell
Hi, I'm setting up a template for a form. I have a full-page table that I've
locked down to one page (i.e. no matter how much text I add, it will never adjust the table cells to carry over to more than one page). This works fine, except if I need to add more text than usual. I then need to manually adjust the font size to fit the text into that table cell. It's not a huge issue, but I'd like to have the text automatically increase/decrease size to always fill the dimensions of the cell. I'm pretty sure I've seen something like this before, but I can't remember if it was in Word or some other program. Any suggestions on where I can enable such an option, if possible? Thanks in advance! Jayson |
#2
|
|||
|
|||
Autofit text in table cell
Yes, there is such a setting. In the Table Properties, on the Cell tab,
click Options. In the Cell Options dialog, check the box for "Fit text." Just don't overdo it! -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "jkempinger" wrote in message ... Hi, I'm setting up a template for a form. I have a full-page table that I've locked down to one page (i.e. no matter how much text I add, it will never adjust the table cells to carry over to more than one page). This works fine, except if I need to add more text than usual. I then need to manually adjust the font size to fit the text into that table cell. It's not a huge issue, but I'd like to have the text automatically increase/decrease size to always fill the dimensions of the cell. I'm pretty sure I've seen something like this before, but I can't remember if it was in Word or some other program. Any suggestions on where I can enable such an option, if possible? Thanks in advance! Jayson |
Thread Tools | |
Display Modes | |
|
|