If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
add detail page to a Gane-Sarson diagram
The methods suggested in the Visio help file appear to break the diagram,
rather than add a new detail (drilldown) page. "Right-click process and select New Detail Page" rearranges all of the interfaces and processes vertically; all data flows are disconnected from their targets. "Right-click process icon in DFD Model Explorer and click New Sub-Process" adds a new sub-process below the selected process; all data flows in the existing model are now broken (they all turn red and the output window fills with errors). |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cannot force page # | klam | General Discussion | 3 | October 22nd, 2004 09:59 PM |
Changing Page Numbers | Wood | General Discussion | 1 | August 14th, 2004 05:54 AM |
Omit Page # on first page | JethroUK© | New Users | 16 | June 17th, 2004 09:20 PM |
odd page section breaks | Bill Mitchell | Formatting Long Documents | 6 | June 17th, 2004 02:20 PM |
NUMBERING the pages | Bob | New Users | 7 | June 14th, 2004 12:20 AM |