|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 3rd, 2009, 06:32 AM
posted to microsoft.public.access.tablesdbdesign
|
|||
|
|||
Access 2003
Im trying to change the ruler form cm to mm as i need to do exact
measurments ont a report.. but i also need to no if i want to change it back to cm, if you do it the same way? please could you let me Know asap. 
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
