If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Controlling connectors on cross-overs (intersections)
When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does one make one line jump over the other line with a half circle (standard pipeline nomenclature for cross-overs)? Also, is it possible to have regular lines behave this was too, or only connector type lines? Thanks, Mike |
#2
|
|||
|
|||
Controlling connectors on cross-overs (intersections)
The ability to control the 'lines' is limited to connectors. To change how
the route go to page setup, select layout and routing and adjust line jumps. al "Mike McCarty" Mike wrote in message ... When two connector lines intersect, one of them will have a break or won't have a break depending on the behavior settings for those lines. How does one make one line jump over the other line with a half circle (standard pipeline nomenclature for cross-overs)? Also, is it possible to have regular lines behave this was too, or only connector type lines? Thanks, Mike |
#3
|
|||
|
|||
Controlling connectors on cross-overs (intersections)
You can do so manually with regular lines by using a half circle jump
shape....locate it where you want it and then connect lines to it. Changes may require manual adjustments but it does work well. Doug.S "AlEdlund" wrote in message ... The ability to control the 'lines' is limited to connectors. To change how the route go to page setup, select layout and routing and adjust line jumps. al "Mike McCarty" Mike wrote in message ... When two connector lines intersect, one of them will have a break or won't have a break depending on the behavior settings for those lines. How does one make one line jump over the other line with a half circle (standard pipeline nomenclature for cross-overs)? Also, is it possible to have regular lines behave this was too, or only connector type lines? Thanks, Mike |
Thread Tools | |
Display Modes | |
|
|