If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Units and page layout.
Okay, I understand Milimeters (decimal) and
Inches, but... Why it always starts with: Page size: Letter and Units: Inches (decimal) How can I tell this stupid program to use A4 and Inches (meaning 1", 1/2", 1/4" and not the decimal layout). There is a missing button on the Page setup dialog: "Save as default" so that I don't have to change this settings over and over again! George Valkov |
#2
|
|||
|
|||
Units and page layout.
Set up the page the way you link it and save the document as a Visio
template. Then start from this document in the future. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "George Valkov" wrote in message ... Okay, I understand Milimeters (decimal) and Inches, but... Why it always starts with: Page size: Letter and Units: Inches (decimal) How can I tell this stupid program to use A4 and Inches (meaning 1", 1/2", 1/4" and not the decimal layout). There is a missing button on the Page setup dialog: "Save as default" so that I don't have to change this settings over and over again! George Valkov |
#3
|
|||
|
|||
Units and page layout.
Thank You Mark!
I found that my problem appears because Visio loads the default settings from a template when I am creating a new drawing during the startup wizard. I have overwritten a built-in template with a custom one and it works fine. George Valkov "Mark Nelson [MS]" wrote in message ... Set up the page the way you link it and save the document as a Visio template. Then start from this document in the future. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "George Valkov" wrote in message ... Okay, I understand Milimeters (decimal) and Inches, but... Why it always starts with: Page size: Letter and Units: Inches (decimal) How can I tell this stupid program to use A4 and Inches (meaning 1", 1/2", 1/4" and not the decimal layout). There is a missing button on the Page setup dialog: "Save as default" so that I don't have to change this settings over and over again! George Valkov |
Thread Tools | |
Display Modes | |
|
|