|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 2nd, 2010, 03:16 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Changing units of measure
How do i change the unit of measurement from imperial to metric that comes up
on the drawings as a shadow measurement next to my drawings. I know how to change it on the ruler and grid. thats ok. -- kavulikt 
|
|
#2
June 2nd, 2010, 12:06 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Changing units of measure
On Tue, 1 Jun 2010 19:16:01 -0700, tony wrote:
How do i change the unit of measurement from imperial to metric that comes up on the drawings as a shadow measurement next to my drawings. I know how to change it on the ruler and grid. thats ok. The units of measurement are a funcion of each individual page, to change the units for the page use menu File - Page Setup - Page Properties -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
