If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Document not printing as shown on screen
When I look at my table on screen the margins within the columns are fine.
When printed, the print is very close (too close) to the edge of the column. I have the margins set at .08 but cannot move the tabs within the cel when the data is selected. ?? What is wrong?? I have already gone the route of setting up a new table, then copying the data over to the individual cells but I think that has merely copied the same problem over to the new document. Ideas? |
#2
|
|||
|
|||
Document not printing as shown on screen
Increase the cell margins in the Table Properties dialog.
-- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP, originally posted via msnews.microsoft.com "Donlori" wrote in message ... When I look at my table on screen the margins within the columns are fine. When printed, the print is very close (too close) to the edge of the column. I have the margins set at .08 but cannot move the tabs within the cel when the data is selected. ?? What is wrong?? I have already gone the route of setting up a new table, then copying the data over to the individual cells but I think that has merely copied the same problem over to the new document. Ideas? |
Thread Tools | |
Display Modes | |
|
|