If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Convert Text to Table
I am trying to convert text into a table. I have a number and description
with a dash between them. I am trying to conver this to a table with two columns, the first column for the number (02) and the second for the description. I did a search and replace for the dash and substituted it for a tab. I then selected Table/Convert/Text to Table and select two columns and for the "separate text at" I selected "tab". When I click OK, the text converts to a table but with only one column. Why is it doing this? I thought it would convert the text to two columns at the tab. -- S |
#2
|
|||
|
|||
Convert Text to Table
Works for me here. I suspect the "tab" you substituted is not really a
tab character. In the Find and Replace dialog, you should have clicked in the Replace With box, clicked on More | Special | Tab Character. Sharon wrote: I am trying to convert text into a table. I have a number and description with a dash between them. I am trying to conver this to a table with two columns, the first column for the number (02) and the second for the description. I did a search and replace for the dash and substituted it for a tab. I then selected Table/Convert/Text to Table and select two columns and for the "separate text at" I selected "tab". When I click OK, the text converts to a table but with only one column. Why is it doing this? I thought it would convert the text to two columns at the tab. |
Thread Tools | |
Display Modes | |
|
|