If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
?create report from crosstab query without set number of columns
I am trying to report data for multiple reps where each rep can have a
different number of entries. ie: rep 'A' has 5 columns, rep 'B' has 10 columns and rep 'C' has 15 columns. The number of columns will vary from month to month. |
#2
|
|||
|
|||
Take a look at the Crosstab.mdb in the download from
http://www.invisibleinc.com/divFiles.cfm?divDivID=4 -- Duane Hookom MS Access MVP -- "dv42" wrote in message ... I am trying to report data for multiple reps where each rep can have a different number of entries. ie: rep 'A' has 5 columns, rep 'B' has 10 columns and rep 'C' has 15 columns. The number of columns will vary from month to month. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Report based on crosstab query problem | [email protected] | Setting Up & Running Reports | 1 | February 18th, 2005 10:26 PM |
Union Query Not Returning A Value | Jeff G | Running & Setting Up Queries | 2 | October 19th, 2004 05:47 PM |
Dynamic crosstab query report | Richardson | Setting Up & Running Reports | 1 | August 31st, 2004 10:13 PM |
Taher | Setting Up & Running Reports | 1 | August 31st, 2004 09:07 PM | |
Display Parameter from Form on Report | sara | Setting Up & Running Reports | 10 | July 19th, 2004 04:54 PM |