If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Report view is incorrect
Do I need to add the module to the report, or leave the action as the current
select Macro? "CMTH" wrote: That unfortunatly did not work. I received the 'Conversion finished' message and then tried running the report with the same results. Any other suggestions? Thanks in advance! "CMTH" wrote: I have created a report that when opened, runs a macro that outputs the report to an excel spreadsheet and also sends the report in a snapshot format to an email in Outlook. The problem is...the information in the email attachment is correct, but after the macro finishes running, the report opens and only displays a couple lines of the information. If the report is opened without the macro running, all information is displayed correctly. Any help will be greatly appreciated! |
#2
|
|||
|
|||
Report view is incorrect
The macro name is still listed in the activate property line.
How do I add the module to the report? Sorry if the question, but I am self taught and just being to work with code. "Jerry Whittle" wrote: Add the module to the report. It's probably still looking at the macro. -- Jerry Whittle, Microsoft Access MVP Light. Strong. Cheap. Pick two. Keith Bontrager - Bicycle Builder. "CMTH" wrote: Do I need to add the module to the report, or leave the action as the current select Macro? "CMTH" wrote: That unfortunatly did not work. I received the 'Conversion finished' message and then tried running the report with the same results. Any other suggestions? Thanks in advance! "CMTH" wrote: I have created a report that when opened, runs a macro that outputs the report to an excel spreadsheet and also sends the report in a snapshot format to an email in Outlook. The problem is...the information in the email attachment is correct, but after the macro finishes running, the report opens and only displays a couple lines of the information. If the report is opened without the macro running, all information is displayed correctly. Any help will be greatly appreciated! |
Thread Tools | |
Display Modes | |
|
|