If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Control Source
In a form, I have the control source as a calculation. It gives me future
dates for an appointment. I need the value (Dates) of that calculation to be recorded in a table because I need to use that calculation value for a query. I want to be able to make paremeter query. Many Thanks |
#2
|
|||
|
|||
Greg via AccessMonster.com wrote:
In a form, I have the control source as a calculation. It gives me future dates for an appointment. I need the value (Dates) of that calculation to be recorded in a table because I need to use that calculation value for a query. I want to be able to make paremeter query. No you don't need to store it in the table. Just put the same calculation into your query. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Manipulating Control Source 2nd Time | coronacity | Using Forms | 4 | August 10th, 2005 10:25 PM |
Field views not showing up on Control source | ssciarrino | Using Forms | 3 | April 22nd, 2005 07:00 PM |
Data Entry Mode | bdehning | Using Forms | 17 | November 22nd, 2004 04:49 PM |
Access Calendar | lost | General Discussion | 2 | July 7th, 2004 04:58 AM |
How to assign value to a report control? | Peter | General Discussion | 3 | June 29th, 2004 11:17 AM |