If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Runnig Spanish Access application into English version
I have developed an Access application with the Spanish version of Access
2000. I have tried to run this application with an English version of Access 2000. The application starts, runs some forms, and give errors such as variables not found, "divided by zero" error, type mismatch, .... I have been told it is due to Spanish caracters not being recognized by the English version.... Fine!! But, could I mend it?. Is it any way to use an application to change all unknown Spanish caracters into recognized ones for English? Could I edit the whole Access aplication in Visual BAsic so that I can change the caracters with "search and replace" options ? Thanks, Jose |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transpose | john | Using Forms | 1 | November 24th, 2004 06:16 PM |
is Access 2003 any better than XP? | Gorb | General Discussion | 4 | November 11th, 2004 09:44 PM |
store access application | ria | New Users | 3 | October 22nd, 2004 09:31 PM |
Exporting Access data to calendar application | Laser Man | New Users | 2 | October 21st, 2004 06:52 PM |
Can't Open MDE | LouisianaLinda | General Discussion | 10 | September 18th, 2004 01:21 PM |