If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A6 Borderless printing help
I am trying to print anA6 invitation as a landscape, borderless document on a
new lexmark 6530 that supports A6 borderless printing. I created it in Publisher 2003. I have the margins set to 0 all around. When I print the document, the left and bottom are in fact borderless but the top and right sides are not. I have the page layout and paper size set to A6 borderless, though I have also tried doing a custom size with the demensions entered. Any help would be immensely appreciated as I have been at this with no luck for hours. As far as I can tell, all the needed drivers are installed. Thanks! |
#3
|
|||
|
|||
A6 Borderless printing help
By the way, I should also mention that I've tried saving it as a jpeg and
printing it using the Lexmark productivity center -- same thing happens. "Sara K" wrote: I am trying to print anA6 invitation as a landscape, borderless document on a new lexmark 6530 that supports A6 borderless printing. I created it in Publisher 2003. I have the margins set to 0 all around. When I print the document, the left and bottom are in fact borderless but the top and right sides are not. I have the page layout and paper size set to A6 borderless, though I have also tried doing a custom size with the demensions entered. Any help would be immensely appreciated as I have been at this with no luck for hours. As far as I can tell, all the needed drivers are installed. Thanks! |
#4
|
|||
|
|||
A6 Borderless printing help
You might want to see what Lexmark has to say. I could not find any support
documents for your specific printer but there is this generic article. Your printer may be just too new for support documents. How to Enable Borderless Printing on Lexmark Inkjet Printers http://support.lexmark.com/cgi-perl/...ocid=ENUS17820 -- Mary Sauer MSFT MVP http://office.microsoft.com/ http://msauer.mvps.org/ news://msnews.microsoft.com "Sara K" wrote in message news By the way, I should also mention that I've tried saving it as a jpeg and printing it using the Lexmark productivity center -- same thing happens. "Sara K" wrote: I am trying to print anA6 invitation as a landscape, borderless document on a new lexmark 6530 that supports A6 borderless printing. I created it in Publisher 2003. I have the margins set to 0 all around. When I print the document, the left and bottom are in fact borderless but the top and right sides are not. I have the page layout and paper size set to A6 borderless, though I have also tried doing a custom size with the demensions entered. Any help would be immensely appreciated as I have been at this with no luck for hours. As far as I can tell, all the needed drivers are installed. Thanks! |
#5
|
|||
|
|||
A6 Borderless printing help
I have experienced a similar problem trying to print an A6 borderless card on
A6 paper. The Canon Pixma MP 600 has a mind of its own. No matter what combination of paper, page set up etc is entered, as soon as the borderless check box is checked the printer insists on opting for A4 papers which result in borders around the images. However, using a 'blank publication' - 'side fold of 4 pages', and using either pages one and four or pages two and three, and editing the A6 (1/2 A4) section to your needs. In printer options check the borderless box, increase the Extension slider, margins to '0'. Leave the printer thinking it is using A4 paper but use A6 size. I am now beginning to print borderless A6 cards after hours assuming that it would be a simple procedure with a relatively new printer and MS Publisher 2003. There is a choice of two side fold blank publications so one of them will meet your needs. I hope this may be of use. -- Just Emma "Sara K" wrote: I am trying to print anA6 invitation as a landscape, borderless document on a new lexmark 6530 that supports A6 borderless printing. I created it in Publisher 2003. I have the margins set to 0 all around. When I print the document, the left and bottom are in fact borderless but the top and right sides are not. I have the page layout and paper size set to A6 borderless, though I have also tried doing a custom size with the demensions entered. Any help would be immensely appreciated as I have been at this with no luck for hours. As far as I can tell, all the needed drivers are installed. Thanks! |
Thread Tools | |
Display Modes | |
|
|