If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Margins format
hi,
i have a document in 2007 where users pasted different pieces including Excel tables. How do i bring them all to a single margin format as some pages are wider than the others? i tried the format brush tool but it did not work Thank you , -- ______ Regards, Greg |
#2
|
|||
|
|||
Margins format
In Page Setup, you can set the margins for "Whole document," which will take
care of the margins even if the document contains more than one section. It will not, however, affect the width of existing tables. What you'll need to do for those is to set the table width (Table tab of Table Properties) to 100%. Unfortunately, unless you use a macro, there is no way to do this automatically for all tables. If the Excel "tables" are actually embedded sheets or have been pasted as images, then this approach will not help. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "Greg" wrote in message ... hi, i have a document in 2007 where users pasted different pieces including Excel tables. How do i bring them all to a single margin format as some pages are wider than the others? i tried the format brush tool but it did not work Thank you , -- ______ Regards, Greg |
Thread Tools | |
Display Modes | |
|
|