If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Word wrapping in tables is incorrect in Draft view
When I view a document with a table in Draft view, it frequently displays
differently from how it displays in Print view. In particular, a cell which does not wrap over 2 lines in Print view is often shown to wrap in Draft view. I'm not sure of the exact circumstances in which this occurs. I've seen it in columns which have cells with a single word, and the table is the width of the page. Is there a way to fix this? Thanks, Calum |
#2
|
|||
|
|||
Word wrapping in tables is incorrect in Draft view
Draft view is not meant to be in any way WYSIWYG. It's only to show *what*
the text is, not *where* it is. If you want to see it laid out as it will print, use Print view. -- Regards, Jay Freedman Microsoft Word MVP FAQ: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. Calum MacLean wrote: When I view a document with a table in Draft view, it frequently displays differently from how it displays in Print view. In particular, a cell which does not wrap over 2 lines in Print view is often shown to wrap in Draft view. I'm not sure of the exact circumstances in which this occurs. I've seen it in columns which have cells with a single word, and the table is the width of the page. Is there a way to fix this? Thanks, Calum |
Thread Tools | |
Display Modes | |
|
|