|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 19th, 2004, 02:01 PM
|
|||
|
|||
Refresh Animations & Go To Slide
Steve,
Thanks again for your help. The problem was that I'd forgotten an "End With" within the code that was blocking the code. Marcos 
|
|
#2
May 19th, 2004, 04:47 PM
|
|||
|
|||
|
Refresh Animations & Go To Slide
In article , Mxleite wrote:
Steve, Thanks again for your help. The problem was that I'd forgotten an "End With" within the code that was blocking the code. Yep, that'll do it. A tip: always pick Debug, Compile [project name] before running the code. It'll often catch this kind of glitch and will highlight the problem so you can fix it right then and there. -- Steve Rindsberg, PPT MVP PPT FAQ: www.pptfaq.com PPTools: www.pptools.com
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
