Visibility

Joe C · February 9th, 2006, 05:10 PM posted to microsoft.public.access.forms

Hello,

I have a question.

I have a continous Data Entry form that I have set visibility of several
controls to be turned on and off based on a selection in a combo box. When
condition one is met control set one is turned on. When I move to record two,
thus condition two, control set one is turned off and control set two is
turned on..... for all records. Can I set the conditions to be record
specific thus leaving me with a different visible set for each record?

Thanks

Rick B · February 9th, 2006, 05:21 PM posted to microsoft.public.access.forms

You can (using the CURRENT event) but I don't think you can use it in a
continuous form.

--
Rick B

"Joe C" wrote in message
...
Hello,

I have a question.

I have a continous Data Entry form that I have set visibility of several
controls to be turned on and off based on a selection in a combo box. When
condition one is met control set one is turned on. When I move to record
two,
thus condition two, control set one is turned off and control set two is
turned on..... for all records. Can I set the conditions to be record
specific thus leaving me with a different visible set for each record?

Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Data access page control visibility based on value of another cont	Mona-ABE	General Discussions	2	March 2nd, 2005 03:01 PM
a control visibility	\Allen Iverson\	Using Forms	5	February 4th, 2005 02:10 AM
a control visibility	\Allen Iverson\	Setting Up & Running Reports	5	February 4th, 2005 02:10 AM
Correct visibility of fields on form depending on conditions	Sammie	Using Forms	2	February 1st, 2005 02:55 AM
worksheet tab visibility	andy	Worksheet Functions	1	May 20th, 2004 01:57 PM