|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 14th, 2004, 06:49 PM
|
|||
|
|||
I cannot print a Viso 2003 file to one page.
Using Pagesetup, my printer page and drawing page seem to be aligned, same
size, etc. However, I have printing the bottom 1/3 of the drawing page. What can I do. 
|
|
#2
November 15th, 2004, 03:55 AM
|
|||
|
|||
|
Please download and install Service Pack 1 for Visio 2003.
-- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Gregg Jones" Gregg wrote in message ... Using Pagesetup, my printer page and drawing page seem to be aligned, same size, etc. However, I have printing the bottom 1/3 of the drawing page. What can I do.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Photo Editor - print file names on page | Denise Freiburger | General Discussions | 1 | July 7th, 2004 07:02 AM |
| You do not have exclusive access... ERROR | Robin | General Discussion | 1 | July 6th, 2004 01:18 AM |
| Unsafe Attachments | Ron | Installation & Setup | 2 | June 9th, 2004 01:55 AM |
| Product Key for Office XP | P.G.Indiana | Setup, Installing & Configuration | 1 | June 7th, 2004 03:22 AM |
| GPO Office 2003 | Tony | Setup, Installing & Configuration | 1 | May 12th, 2004 10:42 AM |
Linear Mode
