If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Form view / Design view - looses chart changes?
I have created a graph using a form. In design view I have edited the data
sheet to show different series headers and changed the order of the series. I can see these changes have been made in the design view. However when I switch back to form view the changes are lost both in form view and then back in design view? I've tried saving before leaving design view - this doesn't seem to help Help - why does this happen? is there anyway round it? Thank you |
#2
|
|||
|
|||
If you are setting the changes in the graph data sheet the changes
will never be saved because your graph is based on a query or SQL statement. Try changing the record source of the graph not the graph data sheet. Once you make changes to the record source then formatting the graphs layout can be saved. Hope this helps. On Thu, 10 Mar 2005 08:31:06 -0800, KIM wrote: I have created a graph using a form. In design view I have edited the data sheet to show different series headers and changed the order of the series. I can see these changes have been made in the design view. However when I switch back to form view the changes are lost both in form view and then back in design view? I've tried saving before leaving design view - this doesn't seem to help Help - why does this happen? is there anyway round it? Thank you |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error Opening the same form twice in Datasheet View | Byzantine | General Discussion | 1 | January 27th, 2005 07:05 PM |
Form margins not matching design view | Max Moor | Using Forms | 1 | January 25th, 2005 12:51 AM |
Cursor Positioning | Colin Hammond | General Discussion | 3 | November 2nd, 2004 08:42 PM |
can't view switchboard form in design view | anita | Using Forms | 2 | September 7th, 2004 06:56 PM |
how to start a form in datasheet view from the switchboard | William Wenjie Wang | New Users | 3 | June 1st, 2004 04:30 AM |