|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 24th, 2007, 05:08 PM
posted to microsoft.public.outlook.contacts
|
|||
|
|||
Outlook 2007 not reconciling names against my 'Contacts'
I am using Outlook 2007.
When creating a new e-mail message, Outlook is not reconciling the names in the address field against the Contacts list. It will check names in my companies 'global' list, but not my personal contacts list. I want to reconcile against my personal contacts before checking the companies 'global' list. I have searched help and this forum but have been unable to find the right combination of keywords to locate the steps to resolve this. 
|
|
#2
May 24th, 2007, 08:29 PM
posted to microsoft.public.outlook.contacts
|
|||
|
|||
|
Outlook 2007 not reconciling names against my 'Contacts'
DFB wrote:
I am using Outlook 2007. When creating a new e-mail message, Outlook is not reconciling the names in the address field against the Contacts list. It will check names in my companies 'global' list, but not my personal contacts list. I want to reconcile against my personal contacts before checking the companies 'global' list. Open the Address Book interface, click ToolsOptions, and set the checking order there. -- Brian Tillman
|
|
#3
May 24th, 2007, 08:49 PM
posted to microsoft.public.outlook.contacts
|
|||
|
|||
|
Outlook 2007 not reconciling names against my 'Contacts'
Thanks Brian!
"Brian Tillman" wrote: DFB wrote: I am using Outlook 2007. When creating a new e-mail message, Outlook is not reconciling the names in the address field against the Contacts list. It will check names in my companies 'global' list, but not my personal contacts list. I want to reconcile against my personal contacts before checking the companies 'global' list. Open the Address Book interface, click ToolsOptions, and set the checking order there. -- Brian Tillman
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
