If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Line curve in Flowchart
I want to connect the head and tail from and to the same process, ie.
recursion. I am using the Line-curve connector, it only has 1 anchor point, however, I would like to make a more round shap, is it possible? |
#2
|
|||
|
|||
Line curve in Flowchart
Use the standard connector from the Connector Tool. You can right-click on
the connector and switch to a curved route. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Alan T" wrote in message ... I want to connect the head and tail from and to the same process, ie. recursion. I am using the Line-curve connector, it only has 1 anchor point, however, I would like to make a more round shap, is it possible? |
Thread Tools | |
Display Modes | |
|
|