If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
I can print only a portion of the Drawing Page
On Pagesetup, my drawing page and printing page are aligned and matched.
However I can only print what is in my current view and that is the bottom 1/3 of the drawing page. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Print multiple copies and change id to make each page unique | Brian K. Sheperd | Setting Up & Running Reports | 4 | November 15th, 2004 04:33 PM |
Print will only show 1/4 of drawing at top of page | JohnDominic | Visio | 1 | November 9th, 2004 05:23 AM |
Headers and Footers | Pat Jennings | Page Layout | 9 | July 29th, 2004 07:39 PM |
Page prints differently than shown in Print Preview | Suzanne S. Barnhill | Page Layout | 0 | July 22nd, 2004 03:42 PM |
Omit Page # on first page | JethroUK© | New Users | 16 | June 17th, 2004 09:20 PM |