If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Duplex no longer working
I have a single page report coded to print two copies to a duplex
printer. It used to give me a single sheet of paper with one copy of the report on each side of a piece of paper. Now, the printer passes the page through the duplexer but only prints one side and I end up with two pieces of paper. This happens even with a second duplex printer. The last time I printed this report was in April so has an update altered Access 2007 so as to treat the printing of multiple copies differently? |
#2
|
|||
|
|||
Duplex no longer working
Try printing on a printer that does not have deplex capibility to see if you
get the extra sheet between data. You may have spillover due to page width or lenght causing a blank appearing page. -- Build a little, test a little. "anthony" wrote: I have a single page report coded to print two copies to a duplex printer. It used to give me a single sheet of paper with one copy of the report on each side of a piece of paper. Now, the printer passes the page through the duplexer but only prints one side and I end up with two pieces of paper. This happens even with a second duplex printer. The last time I printed this report was in April so has an update altered Access 2007 so as to treat the printing of multiple copies differently? |
#3
|
|||
|
|||
Duplex no longer working
Good idea, but no spillage
|
Thread Tools | |
Display Modes | |
|
|