|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 20th, 2007, 09:29 PM
posted to microsoft.public.word.docmanagement
|
|||
|
|||
Change default unit of measurement for indents-spacing-images
I'm still getting used to 2003 and the default "ch" and lines drive me crazy;
can I change the defaults to points (for spacing) and inches for editing images, like earlier versions of Word? 
|
|
#2
February 20th, 2007, 10:08 PM
posted to microsoft.public.word.docmanagement
|
|||
|
|||
|
Change default unit of measurement for indents-spacing-images
In Word, click on Tools | Options | General | Measurement units: choose
your preferred unit of measure | OK. If Word won't let you change the setting there, then see http://support.microsoft.com/?kbid=299339 "You cannot change ruler measurement unit from character units after upgrade to Office XP" or http://www.gmayor.com/Character_Units.htm . Diane B wrote: I'm still getting used to 2003 and the default "ch" and lines drive me crazy; can I change the defaults to points (for spacing) and inches for editing images, like earlier versions of Word?
|
|
#3
February 20th, 2007, 10:19 PM
posted to microsoft.public.word.docmanagement
|
|||
|
|||
|
Change default unit of measurement for indents-spacing-images
THANK YOU THANK YOU THANK YOU!!! that worked!
"garfield-n-odie [MVP]" wrote: In Word, click on Tools | Options | General | Measurement units: choose your preferred unit of measure | OK. If Word won't let you change the setting there, then see http://support.microsoft.com/?kbid=299339 "You cannot change ruler measurement unit from character units after upgrade to Office XP" or http://www.gmayor.com/Character_Units.htm . Diane B wrote: I'm still getting used to 2003 and the default "ch" and lines drive me crazy; can I change the defaults to points (for spacing) and inches for editing images, like earlier versions of Word?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
