If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Does not switch from VBE to Access Main Window
In Access 2002 (SP2) with WinXP, has anyone noticed a
strange behavior where if you open a Form in design mode and select a control on your form (ie: a combo box) and then select the Properties (F4) of that control, then go to add an Event for that control (ie: After Update), and once you are in the VBE and you want to switch back to the main Access window, Access will not switch over? When I open my Access DB, I get the Access icon in my Taskbar. Then, when I am in the VBE, I get another icon in my Taskbar, which is exactly what I want - in my Access Options (Tools/Options) in the "Show" section on the "View" Tab, I have the "Windows in Taskbar" unchecked because I only want to have 2 possible icons in my Taskbar; VBE and the Main Access Window. This is where the strange behavior occurs. When I am in my VBE adding the code for my control event and I want to switch back to my Main Access window by clicking on the other icon (not VBE) in the Taskbar, my Properties (F4) window keeps popping up rather than switching me back to my Form. However, if I close the Properties (F4) window, Access will switch me to my Form just fine - it appears like the Properties window has taken over. This is more of a nuisance than anything, and I was wondering if anyone has experienced this before. |
#2
|
|||
|
|||
Does not switch from VBE to Access Main Window
Up to Access 97, the programming interface was actually part of Access.
In Access 2000, that was pulled out, and the VB interface was loosely cobbled together with Access. The integration is far from seamless, and yes, it does show badly. -- Allen Browne - Microsoft MVP. Perth, Western Australia. Tips for Access users - http://allenbrowne.com/tips.html Reply to group, rather than allenbrowne at mvps dot org. "Tony_VBACoder" wrote in message ... In Access 2002 (SP2) with WinXP, has anyone noticed a strange behavior where if you open a Form in design mode and select a control on your form (ie: a combo box) and then select the Properties (F4) of that control, then go to add an Event for that control (ie: After Update), and once you are in the VBE and you want to switch back to the main Access window, Access will not switch over? When I open my Access DB, I get the Access icon in my Taskbar. Then, when I am in the VBE, I get another icon in my Taskbar, which is exactly what I want - in my Access Options (Tools/Options) in the "Show" section on the "View" Tab, I have the "Windows in Taskbar" unchecked because I only want to have 2 possible icons in my Taskbar; VBE and the Main Access Window. This is where the strange behavior occurs. When I am in my VBE adding the code for my control event and I want to switch back to my Main Access window by clicking on the other icon (not VBE) in the Taskbar, my Properties (F4) window keeps popping up rather than switching me back to my Form. However, if I close the Properties (F4) window, Access will switch me to my Form just fine - it appears like the Properties window has taken over. This is more of a nuisance than anything, and I was wondering if anyone has experienced this before. |
Thread Tools | |
Display Modes | |
|
|