|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 1st, 2009, 04:31 PM
posted to microsoft.public.visio.general
|
|||
|
|||
how can you change a shape label?
i used to use visio 2003 and could change shape labels by right-clicking on a
shape, going to format/protection or behaviour and changing it here i don't seem to have this option in 2007 and can't find it anywhere else! can anyone help? (by shape label, i mean the bit that appears after 'Shape Data' above the properties table) 
|
|
#2
April 1st, 2009, 05:27 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
how can you change a shape label?
On Wed, 1 Apr 2009 08:31:02 -0700, mel
wrote: i used to use visio 2003 and could change shape labels by right-clicking on a shape, going to format/protection or behaviour and changing it here i don't seem to have this option in 2007 and can't find it anywhere else! can anyone help? (by shape label, i mean the bit that appears after 'Shape Data' above the properties table) Do you mean the menu Format - Special? It is normally disabled, menu Tools - Options - Advanced and enable "Run in developer mode" -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/
|
|
#3
April 2nd, 2009, 09:11 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
how can you change a shape label?
ah fantastic, tha's exactly it!
thanks very much "Paul Herber" wrote: On Wed, 1 Apr 2009 08:31:02 -0700, mel wrote: i used to use visio 2003 and could change shape labels by right-clicking on a shape, going to format/protection or behaviour and changing it here i don't seem to have this option in 2007 and can't find it anywhere else! can anyone help? (by shape label, i mean the bit that appears after 'Shape Data' above the properties table) Do you mean the menu Format - Special? It is normally disabled, menu Tools - Options - Advanced and enable "Run in developer mode" -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
