If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Datasheet question again
I SEE the scrollbars...but what i'm saying is that the subform -- which is
supposed to be viewd in datasheet view, is not being viewed that way within the main form. I can't view ALL thte subform's data in the main form unless I completley maximize that subform's' width and height to show as many fields as possible. "Rick Brandt" wrote: MacNut2004 wrote: scrollbars are enabled on both the subform and the form... I don't understand it then. If the form being shown within the subform control has scrollbars enabled then you should see them when viewing the main form. -- Rick Brandt, Microsoft Access MVP Email (as appropriate) to... RBrandt at Hunter dot com |
#12
|
|||
|
|||
Datasheet question again
MacNut2004 wrote:
I SEE the scrollbars...but what i'm saying is that the subform -- which is supposed to be viewd in datasheet view, is not being viewed that way within the main form. I can't view ALL thte subform's data in the main form unless I completley maximize that subform's' width and height to show as many fields as possible. Do you have the default view of the form set to Datasheet? -- Rick Brandt, Microsoft Access MVP Email (as appropriate) to... RBrandt at Hunter dot com |
#13
|
|||
|
|||
Datasheet question again
i have the default view of the SUBFORM set to datasheet, but not hte main
form because I have a drop down in the form header for the main form that i want to show up. "Rick Brandt" wrote: MacNut2004 wrote: I SEE the scrollbars...but what i'm saying is that the subform -- which is supposed to be viewd in datasheet view, is not being viewed that way within the main form. I can't view ALL thte subform's data in the main form unless I completley maximize that subform's' width and height to show as many fields as possible. Do you have the default view of the form set to Datasheet? -- Rick Brandt, Microsoft Access MVP Email (as appropriate) to... RBrandt at Hunter dot com |
|
Thread Tools | |
Display Modes | |
|
|