If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
First page is always blank
I want a certain header, when it appears, always to be at the top of a
new page. To do this, I have set the header to Force New Page = Before Section. When I do this, it works beautifully, almost just as I intended. The problem is that, because my report always begins with one of these headers, the first page of my report is always blank. Can someone tell me where I've gone wrong and what I need to do to make it so that my header begins at the top of a new page without the first page of the report being blank? Thanks in advance, Kevin |
#2
|
|||
|
|||
First page is always blank
Apologies, I of course meant to post this in reports.
|
Thread Tools | |
Display Modes | |
|
|