|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 8th, 2009, 02:22 PM
posted to microsoft.public.access
|
|||
|
|||
CHANGING A FIELD
Is it possible to change a field from a number to an autonumber after records
have been added. If so, please provide step by step instructions!! I have a donation table that I enter each receipt number (consecutively), it would be better if the table was set up to do this on its own thereby not missing a sequence by mistake. -- Thanks, Pat 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode