If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
blowing up an 8.5 x 11 org. chart to 34" x 44" for a plotter
I can make the background 34" x 44", but I can't seem to take the 8.5 x 11
org. chart and stretch it to fit the page full scale. Any ideas? When I do a select all on the org. chart, it doesn't allow me to grab one corner and stretch it with the shift key down. thx. |
#2
|
|||
|
|||
I don't think this is the right way, but it might be worth a try... File
Page Setup Print Setup, then adjust the scale? Or (this seems to work here...) select all the objects (I just used a rectangle, not ^A), then grab the corner (don't use the Shift key), and drag the whole group to resize. Good luck! "scotty" wrote: I can make the background 34" x 44", but I can't seem to take the 8.5 x 11 org. chart and stretch it to fit the page full scale. Any ideas? When I do a select all on the org. chart, it doesn't allow me to grab one corner and stretch it with the shift key down. thx. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
taking a small org. chart and printing it on a plotter | scotty | Visio | 1 | October 25th, 2004 07:53 PM |
Selecting Charts in a Macro | Herman Merman | Charts and Charting | 1 | August 18th, 2004 12:25 AM |
Chart menu visible property | Sandy V | Charts and Charting | 8 | May 17th, 2004 01:39 PM |
chartgroups,chartobjects etc-confusion to me | R.VENKATARAMAN | Charts and Charting | 1 | April 10th, 2004 04:09 PM |
Styles for chart | Debra Dalgleish | Charts and Charting | 1 | October 3rd, 2003 12:27 PM |