If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Set Focus to specific combo box
I am trying to set focus to a list box. The listbox is accepting bar code
font data. I am trying to only allow parts in the list box when the operator scans them. If they scan an incorrect number not found in the list box I would like an error message stating they scanned an incorrect part number and rescan. How do I complete this task? thanks |
Thread Tools | |
Display Modes | |
|
|