If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
setting default values for tables
How can I control the default paragraph settings of a new table?
I sometimes need to convert text to tables. When I convert, the table applies left and right indentation to text in each cell, though these values are defined as 0 in the original text and style. How can I control the document so these tables are created with 0 indentation? |
#2
|
|||
|
|||
setting default values for tables
Depends on your version of Word. W2003 and later supports table styles. You
can define a default. wrote in message oups.com... How can I control the default paragraph settings of a new table? I sometimes need to convert text to tables. When I convert, the table applies left and right indentation to text in each cell, though these values are defined as 0 in the original text and style. How can I control the document so these tables are created with 0 indentation? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
After the default printer has been changed by code in Access 2003, the application still directs a report to the former default printer. | Peanuts | Setting Up & Running Reports | 1 | February 24th, 2006 02:34 PM |
setting default values based on another control value | Barry | Using Forms | 2 | February 3rd, 2006 08:23 PM |
Changing auto archive default dir by way of reg setting or local policy | Seekyouwillfind | General Discussion | 3 | May 29th, 2005 09:47 AM |
setting up default values | Al_b_m | Using Forms | 1 | December 3rd, 2004 07:23 AM |
How do I change the default setting concerning line spacing? | disseminatethis | General Discussion | 2 | October 1st, 2004 07:47 PM |