|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 12th, 2005, 11:08 PM
|
|||
|
|||
images AND text on command buttons
Hello,
Is there a way to put a .bmp image AND text on the same command button? The captions property has text in it, but when I place a .bmp image into the Picture property, it takes over the text. Any way to get around this? Thanks, Jill 
|
|
#2
August 13th, 2005, 12:14 AM
|
|||
|
|||
|
I would add the text to the bmp image file.
-- Duane Hookom MS Access MVP "Sillie_J" wrote in message ... Hello, Is there a way to put a .bmp image AND text on the same command button? The captions property has text in it, but when I place a .bmp image into the Picture property, it takes over the text. Any way to get around this? Thanks, Jill
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Locking text and images within an area of a slide | Betsy Yanasak | Powerpoint | 1 | May 4th, 2005 03:14 AM |
| Locking text and images within an area of a slide | Betsy Yanasak | Powerpoint | 2 | April 29th, 2005 12:16 AM |
| Retain editable images and allow text boxes in a form PW protected | Shannon | General Discussion | 2 | December 8th, 2004 03:37 PM |
| While copying a group of text boxes and sometimes images creates new single image | New Users | 0 | October 13th, 2004 05:30 AM | |
| Positioning In-Line images after associated text | GFasolt | Publisher | 1 | August 31st, 2004 04:54 PM |
Linear Mode
