|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 17th, 2004, 09:12 AM
|
|||
|
|||
How To Create Form with Tabs In Tabular Layout?
Hi there,
I'm creating a form by 'Create Form in Design View', then I got the 'Detail' section where I add the Tab control to it. How do I change the form to have a Tabular layout? If I create the form by 'Create Form by Using Wizard', then I will have the 'Header', 'Detail', 'Footer'. But I don't know which section should I drag the Tab control to? Your advice please? Thanks. Hylows 
|
|
#2
December 17th, 2004, 12:02 PM
|
|||
|
|||
|
Hi,
The Tab control will go on the Detail section -- HTH Dan Artuso, Access MVP "hylow" wrote in message m... Hi there, I'm creating a form by 'Create Form in Design View', then I got the 'Detail' section where I add the Tab control to it. How do I change the form to have a Tabular layout? If I create the form by 'Create Form by Using Wizard', then I will have the 'Header', 'Detail', 'Footer'. But I don't know which section should I drag the Tab control to? Your advice please? Thanks. Hylows
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need to clear controls of Filter form | Jan Il | Using Forms | 2 | November 28th, 2004 02:04 PM |
| create form | Loulou | Using Forms | 1 | October 13th, 2004 08:26 PM |
| Default values to load up automatically in a form based on value entered in another form | Anthony Dowd | Using Forms | 8 | August 12th, 2004 08:53 AM |
| dlookup | miaplacidus | Using Forms | 9 | August 5th, 2004 09:16 PM |
| Searching Records | Melissa Lambino | New Users | 6 | July 20th, 2004 04:51 AM |
Linear Mode
