If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Printing master and sub documents with linked pictures
I am printing a large manual that I created in Word. The master document is
linked to 60-70 sub documents that have pictures included that were added to the documents using the Link-to-File format to enable changing of pictures later as the manual is utilized for multiple locations. When I print the document, the pictures are displayed randomly. All picture sites have the box, but depending on the print time, pictures are not displayed when printing. it is not consistent in which ones are visible between the printings. I have also tried to expand all of the documents and then save the master doc as a full document, and then printing. This is also not consistent, losing variable pictures at variable times. the doc size is very large at over 3.6 kb. when expanded |
#2
|
|||
|
|||
Could be a memory problem. If you navigate through the document a page at a
time, does it take a few seconds or more for Word to "paint" each picture on screen. When I've had documents like that in the past, I've had to page through the document and allow each picture to be painted, before going to print, in order for all the pictures to be rendered in the printout. Hope that helps Regards, Chad "ron@odyssey" wrote in message ... I am printing a large manual that I created in Word. The master document is linked to 60-70 sub documents that have pictures included that were added to the documents using the Link-to-File format to enable changing of pictures later as the manual is utilized for multiple locations. When I print the document, the pictures are displayed randomly. All picture sites have the box, but depending on the print time, pictures are not displayed when printing. it is not consistent in which ones are visible between the printings. I have also tried to expand all of the documents and then save the master doc as a full document, and then printing. This is also not consistent, losing variable pictures at variable times. the doc size is very large at over 3.6 kb. when expanded |
Thread Tools | |
Display Modes | |
|
|