If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
[Visio 2007]Prevent a visio elt to be choosen by a link
Hi folks,
As I work on french version, I'm not sure to use the correct Visio terms... I would like a precise Visio elt (most f the time a simple rectangle, with eventually no connection points if this can help), NOT to be automatically selected as an "endpoint", when I want to connect two element with a link. How can I achieve that ? Oriane |
Thread Tools | |
Display Modes | |
|
|