If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Business Contact Manager and Admin Privileges
It appears as though I can only run the BCM when I have admin
privileges. Whenever I take away admin priviledges, the "Business Tools" menu item no longer appears in Outlook 2003. However, when I go to "File -- Data File Management" the BCM shows up as being added. I deleted it and tried adding a new one, but when I go to select a database to connect to I get an error/warning message telling me to make sure the computer is on, database sharing is enabled, etc. Please keep in mind that I have none of these problems when i have admin priviledges enabled. We installed BCM using the following file, which I do not believe is beta: http://www.microsoft.com/downloads/d...displaylang=en I have searched this group and found a similar article, but the post was from 2003 and the BCM in question was a beta version: http://groups.google.com/group/micro...1fb69bed7be574 Could someone offer some insight into the problem? Thank you very much. |
#2
|
|||
|
|||
Business Contact Manager and Admin Privileges
Maybe you should try the BCM group.
-- Russ Valentine [MVP-Outlook] "Levi" wrote in message ps.com... It appears as though I can only run the BCM when I have admin privileges. Whenever I take away admin priviledges, the "Business Tools" menu item no longer appears in Outlook 2003. However, when I go to "File -- Data File Management" the BCM shows up as being added. I deleted it and tried adding a new one, but when I go to select a database to connect to I get an error/warning message telling me to make sure the computer is on, database sharing is enabled, etc. Please keep in mind that I have none of these problems when i have admin priviledges enabled. We installed BCM using the following file, which I do not believe is beta: http://www.microsoft.com/downloads/d...displaylang=en I have searched this group and found a similar article, but the post was from 2003 and the BCM in question was a beta version: http://groups.google.com/group/micro...1fb69bed7be574 Could someone offer some insight into the problem? Thank you very much. |
Thread Tools | |
Display Modes | |
|
|