If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sizing cross functional flow chart bands
I have a vertical cross functional flow chart in Visio 2007 with 4 bands. I
want to resize the first band to make it narrower. I click the band header and use the side green sizing handle and drag it to make it narrower. The band pops back to its previous size. I have read other posts and I cannot figure out what is happening. Any help would be appreciated. JoeP |
#2
|
|||
|
|||
Sizing cross functional flow chart bands
On Fri, 9 Oct 2009 02:41:02 -0700, JoeP wrote:
I have a vertical cross functional flow chart in Visio 2007 with 4 bands. I want to resize the first band to make it narrower. I click the band header and use the side green sizing handle and drag it to make it narrower. The band pops back to its previous size. I have read other posts and I cannot figure out what is happening. Any help would be appreciated. The band header has two handles, only one of them will work for resizing, for a vertical chart it is the right-hand one. The left-hand handle behaves as you found. -- Regards, Paul Herber, Sandrila Ltd. DFD/SSADM for Visio http://www.visio-dfd.sandrila.co.uk/ Now in English, Dutch, French, Portuguese and Spanish |
#3
|
|||
|
|||
Sizing cross functional flow chart bands
Paul,
Thnks for the response but I still cannot reduce the width of the bands. Any other suggestions? Thanks. "Paul Herber" wrote: On Fri, 9 Oct 2009 02:41:02 -0700, JoeP wrote: I have a vertical cross functional flow chart in Visio 2007 with 4 bands. I want to resize the first band to make it narrower. I click the band header and use the side green sizing handle and drag it to make it narrower. The band pops back to its previous size. I have read other posts and I cannot figure out what is happening. Any help would be appreciated. The band header has two handles, only one of them will work for resizing, for a vertical chart it is the right-hand one. The left-hand handle behaves as you found. -- Regards, Paul Herber, Sandrila Ltd. DFD/SSADM for Visio http://www.visio-dfd.sandrila.co.uk/ Now in English, Dutch, French, Portuguese and Spanish |
#4
|
|||
|
|||
Sizing cross functional flow chart bands
On Fri, 9 Oct 2009 13:02:09 -0700, JoeP wrote:
Paul, Thnks for the response but I still cannot reduce the width of the bands. Any other suggestions? Thanks. You can email it to me and I'll have a look. paul at pherber dot com -- Regards, Paul Herber, Sandrila Ltd. DFD/SSADM for Visio http://www.visio-dfd.sandrila.co.uk/ Now in English, Dutch, French, Portuguese and Spanish |
Thread Tools | |
Display Modes | |
|
|