|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 9th, 2009, 08:14 PM
posted to microsoft.public.visio.general
|
|||
|
|||
"Nodes" on flow chart shapes
In Visio 2003 can I add connection "nodes" to flowchart shapes?
|
|
#2
October 10th, 2009, 05:40 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
"Nodes" on flow chart shapes
By "nodes", you mean connection points? Certainly, once the shape is placed.
Can't edit the master shapes on the master stencil though. But, you can create a new stencil and copy these modified shapes to it. Save the new stencil and these shapes will be available whenever you call up that stencil. HTH Wapperdude "Mark" wrote: In Visio 2003 can I add connection "nodes" to flowchart shapes?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
