If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
convert shape to a connector
Is there a way to convert a shape into a connector, ie. add connector start
and end points and handles to a shape? -- Luke Demytko |
#2
|
|||
|
|||
convert shape to a connector
you might consider using the connection point tool on the toolbar (sometimes
hidden under the connector tool). al "Luke Demytko" wrote in message ... Is there a way to convert a shape into a connector, ie. add connector start and end points and handles to a shape? -- Luke Demytko |
#3
|
|||
|
|||
convert shape to a connector
Yes, you can turn a 1-D line into a connector. Select the line and choose
Window Show Shapesheet. Find the Miscellaneous section and then set the ObjType cell to 2. This tells Visio to treat the shape as a routable connector. If you have a 2-D shape, you need to go to Format Behavior and set the Interaction Style to 1-D. Making a 2-D shape behave both as 1-D and routable will not preserve much of the original geometry however. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Al Edlund" wrote in message ... you might consider using the connection point tool on the toolbar (sometimes hidden under the connector tool). al "Luke Demytko" wrote in message ... Is there a way to convert a shape into a connector, ie. add connector start and end points and handles to a shape? -- Luke Demytko |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Visio Shortcuts | [email protected] | Visio | 1 | December 28th, 2006 11:28 PM |
Shape embedded into a shape | Antonio | Visio | 2 | October 30th, 2005 03:04 AM |
Map shape text to custom property? | HLM | Visio | 6 | February 5th, 2005 06:01 AM |
Changing relative position of shape handles | Mike from Oz | Visio | 2 | October 31st, 2004 10:10 PM |
How to relink a shape using wizard in Visio 2003? | MontseMark | Visio | 1 | October 12th, 2004 07:51 PM |