|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 1st, 2005, 07:02 PM
|
|||
|
|||
XP Excel program changes all my files to not duplex as stored
I had excel 8.0 and just upgraded to XP excel 10.0. When I open my excel
files previously stored to print on both sides it changes to print on one side only. Please tell me if there is a setting I need to change, I have thousands of files stored to print on both sides. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cannot access read-only documents. | tomgillane | General Discussion | 14 | February 7th, 2005 10:53 PM |
| Mulitple files Open when Excel is launched | Roberta | Worksheet Functions | 3 | October 4th, 2004 03:56 PM |
| opening several excel files in the same program | GMU | General Discussion | 2 | September 23rd, 2004 10:45 PM |
| completely delete office2000 | jason | Setup, Installing & Configuration | 1 | May 28th, 2004 10:08 AM |
| office 2000 remove tools | bud | Setup, Installing & Configuration | 1 | May 27th, 2004 10:40 AM |
Linear Mode
