If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hardware acceleration
As I understand it, to turn down hardware acceleration you go start, control
panel, display, advance. However in XP Home w/SP 2, start, control panel, then to get to display, I have to click on appearance and themes. Then if I click on display, I get the display properties. The only advance button I see on any of the tabbed pages is under settings and I see no place to turn down hardware acceleration. Could someone please give me further directions? |
#2
|
|||
|
|||
Could someone please give me further directions?
Turn left at the next paragraph marker, travel north through each cell 'till you exit the table, and link into microsoft.public.windowsxp.configuration! -- Regards, Pat Garard Melbourne, Australia _______________________ "kpontrkng" wrote in message ... As I understand it, to turn down hardware acceleration you go start, control panel, display, advance. However in XP Home w/SP 2, start, control panel, then to get to display, I have to click on appearance and themes. Then if I click on display, I get the display properties. The only advance button I see on any of the tabbed pages is under settings and I see no place to turn down hardware acceleration. Could someone please give me further directions? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
lexmark printer X5150 has hardware error 0502 -WHAT IS THIS? | bart | General Discussion | 2 | December 19th, 2004 03:32 PM |
Video/audio hardware compatibility with broadcast | Gary Fugere | Powerpoint | 1 | August 7th, 2004 03:43 AM |
safely remove hardware | roger | General Discussions | 2 | May 9th, 2004 05:43 PM |