If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Distribution list addresses are wrong. How to send e-mail regardle
I have copied old addresses from various sources to a distibution list. My
e-mail to this group is rejected because some of the addreses are wrong (it's a soccer club list). In other e-mail programs the e-mail would be sent and those not delivered would be notified. I could then correct and amend the distribution list accordingly. Outlook refuses to send the e-mail. I don't know which addresses are wrong. How do I set outlook to send the e-mails regardless of the fact that the addresses are incorrect? There must be a setting to allow this to happen? Grateful for any assistance? See error message below: The message could not be sent because one of the recipients was rejected by the server. The rejected e-mail address was blah blah blah. Subject 'Blah Blah United Soccer Club - e-mail housekeeping', Account: 'blah.blah.org.au', Server: 'smtp.vic.blah.com.au', Protocol: SMTP, Server Response: '552 5.5.3 Too many recipients', Port: 25, Secure(SSL): No, Server Error: 552, Error Number: 0x800CCC79 |
#2
|
|||
|
|||
Your ISP may have a limit on bulk mailings to discourage spamming. Note the
comment in the error message that says "Server Response: '552 5.5.3 Too many recipients". Check with your ISP on this issue. If that's the case then restructure your single DL into smaller multiples which can then be sent separately. "Laurie P" wrote in message ... I have copied old addresses from various sources to a distibution list. My e-mail to this group is rejected because some of the addreses are wrong (it's a soccer club list). In other e-mail programs the e-mail would be sent and those not delivered would be notified. I could then correct and amend the distribution list accordingly. Outlook refuses to send the e-mail. I don't know which addresses are wrong. How do I set outlook to send the e-mails regardless of the fact that the addresses are incorrect? There must be a setting to allow this to happen? Grateful for any assistance? See error message below: The message could not be sent because one of the recipients was rejected by the server. The rejected e-mail address was blah blah blah. Subject 'Blah Blah United Soccer Club - e-mail housekeeping', Account: 'blah.blah.org.au', Server: 'smtp.vic.blah.com.au', Protocol: SMTP, Server Response: '552 5.5.3 Too many recipients', Port: 25, Secure(SSL): No, Server Error: 552, Error Number: 0x800CCC79 |
#3
|
|||
|
|||
Hello Wayfarrer
Thank you so much. I'll take it up with my ISP and see how I go. "wayfarrer" wrote: Your ISP may have a limit on bulk mailings to discourage spamming. Note the comment in the error message that says "Server Response: '552 5.5.3 Too many recipients". Check with your ISP on this issue. If that's the case then restructure your single DL into smaller multiples which can then be sent separately. "Laurie P" wrote in message ... I have copied old addresses from various sources to a distibution list. My e-mail to this group is rejected because some of the addreses are wrong (it's a soccer club list). In other e-mail programs the e-mail would be sent and those not delivered would be notified. I could then correct and amend the distribution list accordingly. Outlook refuses to send the e-mail. I don't know which addresses are wrong. How do I set outlook to send the e-mails regardless of the fact that the addresses are incorrect? There must be a setting to allow this to happen? Grateful for any assistance? See error message below: The message could not be sent because one of the recipients was rejected by the server. The rejected e-mail address was blah blah blah. Subject 'Blah Blah United Soccer Club - e-mail housekeeping', Account: 'blah.blah.org.au', Server: 'smtp.vic.blah.com.au', Protocol: SMTP, Server Response: '552 5.5.3 Too many recipients', Port: 25, Secure(SSL): No, Server Error: 552, Error Number: 0x800CCC79 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sending Mail Merge to Email to Multiple Recipients in the Same Mes | Mark V | Mailmerge | 11 | December 20th, 2004 10:58 PM |
Distribution List vs. Contact Items Folder | MEG | Contacts | 1 | December 9th, 2004 09:44 PM |
How do I send a distribution list without displaying addresses? | Annie-o | Contacts | 4 | October 21st, 2004 05:04 PM |
How to send a distribution list from the Outlook Contacts folder . | Albro | General Discussion | 1 | August 15th, 2004 12:51 PM |
Adding email addresses to distribution list ???? | Steve | General Discussion | 1 | July 20th, 2004 04:35 PM |