If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VisPror.WW/VisPrrWW.cab
HI,
I just purchased MS Visio and it tells me that it cannot find VisPror.WW/VisPrrWW.cab and tells me to go look for it. Can anyone tell me what I can do or where to find it? Many Thanks Lambda |
#2
|
|||
|
|||
VisPror.WW/VisPrrWW.cab
Sounds like an issue with the CD. There's a setup file that contains the
database of all the files and settings to install, installer file (*.msi), and it's looking for the files on the CD, they should be there, but are not and hence you get the error. First thing I'd do is clean the CD. If you're not exacly sure how, try these suggestions from a knowledge base article (http://support.microsoft.com/kb/315996): Clean the CD Use a CD-ROM cleaning kit, or gently wipe the silver side of the CD-ROM with a soft, lint-free cotton cloth. Do not use paper. Paper can scratch the plastic and leave streaks. When you clean the CD-ROM, wipe from the center of the disc outward. Do not use a circular motion. *If the disc still does not perform correctly, clean the disc by using warm water or a CD-ROM cleaning kit. Dry the disc thoroughly and then test the disc again. Examine the CD Examine the CD for visible deformation or scratches. If the disc is damaged, contact Microsoft Sales at (800) 360-7561 to obtain a replacement CD. Best Regards, Aaron Rykhus, Visio Support Microsoft Corporation ---------------------------------------------- This posting is provided "AS IS" with no warranties, and confers no rights. |
Thread Tools | |
Display Modes | |
|
|