If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
triggering the 'send' feature in Outlook from Access 2003
I've created an attachment and email from within Access 2003 and it is stored
in Outlook's Outbox until I click on the send/receive menu option in Outlook. Is there a way that I can automatically trigger the 'send' command in Outlook from within Access 2003 so that it does the whole job so to speak? Any help is much appreciated. Regards Byzantine |
#2
|
|||
|
|||
I'd like to know how you "created an attachment and email from within Access
2003"; hopefully, w/o writing code somewhere that I don't know how to do. I do a monthly newsletter and would like to use the email addresses that are in an Access Table to create individual emails w/the news attached. Any help? (Please give me steps.) V "Byzantine" wrote: I've created an attachment and email from within Access 2003 and it is stored in Outlook's Outbox until I click on the send/receive menu option in Outlook. Is there a way that I can automatically trigger the 'send' command in Outlook from within Access 2003 so that it does the whole job so to speak? Any help is much appreciated. Regards Byzantine |
#3
|
|||
|
|||
Take a look at the Access EMail FAQ Tony Toews has at
http://www.granite.ab.ca/access/email.htm If you're not up to writing the code, you could check out Total Access EMailer, from FMS http://www.fmsinc.com/products/emailer/index.asp -- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no e-mails, please!) "Vevah" wrote in message ... I'd like to know how you "created an attachment and email from within Access 2003"; hopefully, w/o writing code somewhere that I don't know how to do. I do a monthly newsletter and would like to use the email addresses that are in an Access Table to create individual emails w/the news attached. Any help? (Please give me steps.) V "Byzantine" wrote: I've created an attachment and email from within Access 2003 and it is stored in Outlook's Outbox until I click on the send/receive menu option in Outlook. Is there a way that I can automatically trigger the 'send' command in Outlook from within Access 2003 so that it does the whole job so to speak? Any help is much appreciated. Regards Byzantine |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
is Access 2003 any better than XP? | Gorb | General Discussion | 4 | November 11th, 2004 09:44 PM |
is Access 2003 any better than XP? | Gorb | Using Forms | 2 | November 11th, 2004 09:20 AM |
Access XP Compared to Access 2003 | Mardene Leahu | New Users | 1 | October 1st, 2004 05:11 AM |
Selecting a contact list | DianaH | General Discussion | 11 | June 22nd, 2004 02:26 AM |
Two versions again-language issue | Otto | Setup, Installing & Configuration | 3 | May 28th, 2004 04:57 AM |