If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Visio - positioning objects
Hello,
How do I set/control the smallest step I can for repositioning an object? 1.with the positioning windows, can I get less than 1mm? 2. When I use arrows where is the setting of the step size? Thanks Tuli |
#2
|
|||
|
|||
Visio - positioning objects
To simplify a complicated answer : When I enter 12345 after the decimal point in the s&p window, it makes ,1235 of it. "Tuli" wrote: Hello, How do I set/control the smallest step I can for repositioning an object? 1.with the positioning windows, can I get less than 1mm? 2. When I use arrows where is the setting of the step size? Thanks Tuli |
#3
|
|||
|
|||
Visio - positioning objects
The step amount depends on the zoom level.
Also, if you hold down the Shift key, you will be able to step at even smaller increments. I suspect that this is based on the Dynamic Grid settings, but you can change to a Fixed grid under Tools / Ruler & Grid "philippe c" wrote in message ... To simplify a complicated answer : When I enter 12345 after the decimal point in the s&p window, it makes ,1235 of it. "Tuli" wrote: Hello, How do I set/control the smallest step I can for repositioning an object? 1.with the positioning windows, can I get less than 1mm? 2. When I use arrows where is the setting of the step size? Thanks Tuli |
Thread Tools | |
Display Modes | |
|
|