If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cannot add connection points
I am trying to add connection points to a text box in Visio 2003.
Specifically, I already have three connection points along the left edge of a text box and I need to add a fourth. I am not able to add any connection points to any shapes in my file - I follow the "help" instructions exactly, but when I CTRL+click, nothing happens. Is there some setting I need to change in order to enable the addition of connection points? |
#2
|
|||
|
|||
Cannot add connection points
On Tue, 1 May 2007 09:35:00 -0700, Adam_R_Same
wrote: I am trying to add connection points to a text box in Visio 2003. Specifically, I already have three connection points along the left edge of a text box and I need to add a fourth. I am not able to add any connection points to any shapes in my file - I follow the "help" instructions exactly, but when I CTRL+click, nothing happens. Is there some setting I need to change in order to enable the addition of connection points? you have selected the connection point tool? -- Regards, Paul Herber, Sandrila Ltd. http://www.sandrila.co.uk/ |
#3
|
|||
|
|||
Cannot add connection points
On Tue, 01 May 2007 17:52:26 +0100, Paul Herber
wrote: On Tue, 1 May 2007 09:35:00 -0700, Adam_R_Same wrote: I am trying to add connection points to a text box in Visio 2003. Specifically, I already have three connection points along the left edge of a text box and I need to add a fourth. I am not able to add any connection points to any shapes in my file - I follow the "help" instructions exactly, but when I CTRL+click, nothing happens. Is there some setting I need to change in order to enable the addition of connection points? you have selected the connection point tool? I've just noticed that if the pointer tool is selected then holding the control key also shows a + near the pointer. This is not the same as the x that marks where a connection point will be added. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|